Tile Expansion Joint

According to the ntca national tile contractors association reference manual an expansion joint is a joint through the tile mortar and reinforcing wire down to the substrate by integrating these stress relievers into the tile assembly expansion and contraction takes place without compromising its integrity.

Tile expansion joint.

It s quite common to see controlled breaks in concrete and those are usually expansion joints. Schluter systems prefabricated movement joint profiles protect tile edges and prevent sound bridges and surface water penetration resulting in a permanent maintenance free installation. Where should movement joints be placed. In almost every case the substrate will move differently to the covering material.

Tile expansion joints tile doctor ceramic porcelain and stone tile expands and contracts with thermal and moisture changes in the environment. Including movement joints in floors enables the tile bed to move in unison with the individual substrates. If you tile over an expansion joint then you need to honor that joint in the tile as well. Recognizing that tile is a facade movement joints are needed to eliminate stresses that can occur between the substrate and the tile due to differing amounts of expansion and contraction.

It is recommended that you err on the side of caution and use the smaller measurement. Latham standard loc strip hard flooring expansion joints are capable of absorbing extension and compression equivalent to 16 or 20 of the undeformed width of their elastic neoprene cores. Learn all about expansion joints here. Expansion joints are a necessary installation on large areas of tiling.

Placement of expansion joints is very important. The use of expansion or movement joints is to safely absorb the movement in the floor or wall from heat expansion or vibration. An expansion joint is in the substrate for instance in concrete. According to the tile council of north america a body that helps set standards for tile installations when installing outdoor tile there must be an expansion joint every 8 feet to 12 feet in each direction.

A movement joint is in the tile only. Movement joints are an integral part of any tile assembly and must be incorporated within the tile field at doorsills and at transitions to walls and other restraining structures to allow movement of the assembly and prevent stresses that can damage the system. Expansion joints are needed because all tiles expand and contract with temperature and moisture changes. It allows for movement in the tile.